|
| |
Arborvitae - A Multi Use Plant
The arborvita is a plant that has many forms, colors, and uses that it is used in almost every type of landscape. One of its major uses is in wind breaks and barriers. Yet it is also used in foundation plantings or as a stand alone specimen in the ...
Guide to Mounting your Satellite Dish
The Dish Network satellite dish is only about 2 feet in diameter. Very much a space saver when it comes to mounting the satellite dish on a wall, fence or garage!Since the satellite dish is small, it is also light and not bulky in size, this also makes it ...
How to Tell If You've Got a Rodent Problem
Older houses are most vulnerable to rodents, but it's possible for them to crop up in just about any neighborhood. There are often large rodent populations in the city, but apartment owners typically rarely see them since their landlords will typically ...
|
|
|
|
| |
Start out by measuring and cutting all your stock according to the cutting list and set it aside. Take the legs and mark out the tapers. The taper starts 20" up from the bottom. The leg tapers to 3-1/2" at the bottom. Repeat for all the legs and cut out.
The legs join the main stretchers at 75°. This cut is best made with a circular saw. Mark your lines, clamp the stock on edge and cut. Flip the stock over to the other edge and make the through cut.
Time for some assembly. On the main stretcher mark a line 1-1/2" from each end. This is the outer face of the leg. Now make a second mark in from one edge 1". This is the top of the leg. Do this for each leg on both stretchers.
Apply some glue to the angled side of the leg and position on the marks you just made on the stretcher. Secure with 4 - 2" screws. Repeat for all the legs.
Position the 3/8" plywood braces on the outside face of the legs butting into
the the bottom face of the main stretcher. Scribe the angle onto the braces with your pencil and cut. Apply some glue to the outside of the legs and secure the braces with 6 screws, three into each leg.
Now draw 2 lines down the length of each top step, offset 3/4" from center. Countersink 5 holes, 3/4" deep in each step. Alternate the holes on each side of center. Position the top onto the stretcher flush with the ends. Secure with screws only.
Finally secure the lower step midway up the leg using screws & adhesive.
That's all there is to it. These saw horses will easily take the load of a lift of plywood or studs. Plus the make a great scaffold. Space about 8' apart and secure a 2 x 10 between them.
About the Author
Get more information including material and tool list and photos of these saw horses at www.all-wood-working-plans.com/heavy-duty-saw-horse.html. Read more articles at www.all-wood-working-plans.com/wood-working-articles.html
|
|
|
|
|
|
 |
Teaching Teens To Build Hammers Home A MessageNPRThe group has enlisted an army of volunteers and a handful of trainees for what it calls a "blitz build" — an effort to rebuild a gutted house in a single day. On a warm spring morning, Jim Beck, the organization's development director, ...and more » |
|
